Steam Turbines
Naturalgas Engines
Biogas Engines
Gas Turbines
 
Gas Turbine Spares
 
Knowledge Base

Products :
 
STEAM TURBINE : Back Pressure Turbine Generator System


The Anama's BP Series is a complete single or multistage backpressure turbine generator set designed to make electricity by reducing steam pressure. It is used where high pressure steam is available but low pressure steam can be used for process or space heating. The BP Series can be used to replace large pressure reducing valves and thereby convert normally wasted energy potential into valuable electricity. Most important is Surplus boiler capacity is not required.
We offer 50kW-5000 kW high efficiency turbine generator set designed for power production at moderate steam flow rates.

The system is designed to “replace” a steam pressure reducing valve, converting energy which is normally wasted in to valuable electricity and can operate with inlet pressure from 8 kg/cm2G - 63 kg/cm2G and exhaust pressure from 0 kg/cm2G - 4 kg/cm2G.
 
Schematic of Backpressure Steam Turbine generator Set :

FEATURES :
  • Easy to install, easy to run and easy to maintain.

  • Fully automatic operation, including re-start after non-critical trips.

  • Uses existing saturated steam generated for your process.

  • High efficiency, low cost system.

  • 20 year design life.

  • Innovative multi-valve technology for maintaining efficiency on varying and partial steam loads.
SYSTEM

INLET PRESSURE
kg/cm2G
INLET TEMPERATURE
EXHAUST PRESSURE (kg/cm2G)
FLOW (kg/hr)
ELECTRICAL POWER OUTPUT (kW)
50 kW
10.5
Saturated (1860C)
1
1227
50
100 kW
10.5
Saturated (1860C)
1
2409
100
150 kW
10.5
Saturated (1860C)
1
3636
150

CALCULATE YOUR SAVINGS (Savings vary with cost of steam)
To find your savings per year use your yearly hours of steam consumption at an AVERAGE steam load (1227 kg/hr for the system of 50 kW, 2409 kg/hr for the system of 100 kW, or 3636 kg/hr for the system of 150 kW), and your current kWh cost from your local utility.
Copyrights | Site Disclaimer